LORIX ONE IP43 AND IP65 LORAWAN™ GATEWAYS

Main System

CPU
ARM® Cortex-A5 600MHz

RAM
128MBytes DDR2 200MHZ

NAND
HW < 1.0d   : 256MBytes flash with PMECC
HW > 1.0d2 : 512MBytes flash with PMECC 

OS/Software

Linux Yocto 4.4
Base configurationfactory reset

Prebuilt with
LORIOT cloud client
TTN cloud client
Semtech packet-forwarder
SSH Server
Toolchain/sources completely open
Now available with the LORIX OS

Connectivity

Ethernet 10/100Mbps with passive PoE 24VDC
Permits to bring powerdata with only 1 cable
SD-CARD Slot to extend/replace the internal flash
USB connector providing serial interface to manage/ the gateway

LoRa™/RF system

SX1301 as LoRa™ RF system kernel
Semtech approved

EU863-870MHz version (EU868)
8 channels, 49 demodulators @ 863-870MHz
RX Sensitivity: -140dBm
TX Power: 27dBm

US902-928MHz version (US915)
8 channels, 49 demodulators @ 902-928MHz
RX Sensitivity: -135dBm
TX Power: 27dBm

AU915-928MHz version (AU915)
8 channels, 49 demodulators @ 915-928MHz
RX Sensitivity: -135dBm
TX Power: 27dBm

Informations

Power supply
PoE 24V passive

Operating ambient temperature
-30 à +55°C

Works with

Indoor (only for EU868 version)
200mm (7,87 inches) inclinable antenna @ 2dBi

Outdoor
IP65 500mm (19,68 inches) antenna @ 4.15dBi

Recommendations

The IP43 version is a semi-waterproof gateway with a drilled closing cap of three holes. These will allow water to drain off in the event of condensation.

The IP65 version is a waterproof gateway with a pre-drilled closing cap, ideal for areas exposed to multi-directional water splashes.

The difference is only in the holes under the cap. A gateway IP65 can become IP43 by drilling the holes if it is to be moved into a different place. Drilling the plug allows you to modify your IP65 gateway to IP43, useful if the latter must be moved to a site with different constraints.